Guidance 95SC2 Suspens Overhaul
Thread Starter
|
Super Moderator
Joined: Jul 2005
Posts: 12,315
From: Slightly off center
Finished last night.
Rides quite smoothly.
Lessons learned by former suspension newbie:
1) It''s all about the angles (and a little "persuasion")
2) 13 yrs of rust takes a good bit of PB Blaster and a good bit of soak time....be patient
3) Keep 1/2 in impact gun away from small rusty nuts unless you enjoy cutting off nuts you trash with it. (only 1 for me)
4) 12 point sockets + 1/2 in impact wrench = metal shavings. Use 6 point sockets. (at least Craftsman warranty comes in handy here as a hack, I can''t afford nor justify Snap-On)
Rides quite smoothly.
Lessons learned by former suspension newbie:
1) It''s all about the angles (and a little "persuasion")
2) 13 yrs of rust takes a good bit of PB Blaster and a good bit of soak time....be patient
3) Keep 1/2 in impact gun away from small rusty nuts unless you enjoy cutting off nuts you trash with it. (only 1 for me)
4) 12 point sockets + 1/2 in impact wrench = metal shavings. Use 6 point sockets. (at least Craftsman warranty comes in handy here as a hack, I can''t afford nor justify Snap-On)
