While doing work on my 95 SC2, I noticed that the e-brake cable does not seem to exert even pressure on the rear calipers; one rear wheel locks completely, but the other rear wheel only partially locks. And the e-brake lever goes to about 8 clicks full range without much resistance (which I know is too loose). Both rear wheels spin freely without the e-brake engaged.

My rear brakes have only been replaced once (about 180K I believe) and the new ones are wearing evenly.

I am aware of the procedure to tighten the e brake cable at the console, but how do I adjust at the caliper to get even tension to both rear wheels?

Mike any pictures from your stack of shop manuals are greatly appreciated.

 

Mike,

Please help.

Thanks

Derf