ISO: DOHC Intake Manifold for a 2000 SW2
 

Need an Intake Manifold for a 2000 SW2 1.9

With the amount of work to change it out in vehicle - I would not use a JY part - I would go new. Using used would greatly increade the chances of a vacuum leak - or breakage on the heater line....

No Idea where to get a new part. I do not know what a JY part is.

JY means junk yard.

I ordered one online. About $250.

Only one I've seen listed in stock so far. Not that that means anything. It's a substitution for the original intake manifold which is no longer available.

https://greatparts.net/collections/b...old-assembly-2

https://cimg4.ibsrv.net/gimg/www.sat...5e883660f5.png
Should say page on this site below.
The link above is to this page on this side
https://cimg5.ibsrv.net/gimg/www.sat...c192298ff7.png
This is a page on the same site as the one shown above, the exact same product at a grossly inflated price. Depends on how you get to it. They are obviously not the same page. Never worked with these folks so I cannot vouch for them.


I did not explore very much on eBay because I figured they would be used, and the listings I did see stated out of stock anyway.

That' s kinda unsettling. I got mine maybe 2 years ago - and I think it was an OEM...

hate to think I got the last one in captivity....

We have 4 cars with that one...

is that a reputable website?

Radiator, water cooler and hoses replaced. put some JB weld on the plastic tube right side where the seam split. good to go
https://cimg0.ibsrv.net/gimg/www.sat...a7b91ebf27.png

Congratulations. I sure hope the JB Weld holds up for you.